[BLDG-SIM] hot water reset

["Mottillo, Maria" <MMottill@xxxxxxxxxxx>]

Hello.

I would like to model temperature reset on on a hot water loop based on
outdoor temperature, using DOE-2.1E, v133. The documentation states that
this is done by setting the PLANT-ASSIGNMENT command HW-SUPPLY-RESET =
LOAD-RESET however this does not seem to make any difference in the energy
consumption results. Any information on whether other keywords need to be
specified would be appreciated, as would any information on the assumptions
in the model (i.e. for what outdoor temperatures is the loop temperature
reset?).

Thanks,
Maria

Maria Mottillo

Project Leader, Building Energy Simulation Team
CANMET Energy Technology Centre - Ottawa
Natural Resources Canada, Government of Canada
580 Booth St., Ottawa, Ontario K1A 0E4

Chef de projet, Groupe de simulation énergétique des bâtiments
Centre de technologie de l'énergie de CANMET - Ottawa
Ressources naturelles Canada, Gouvernement du Canada
580 Booth St. (Ottawa) Ontario K1A 0E4

=====================================================You received this e-mail because you are subscribed
to the BLDG-SIM@xxxxxxxx mailing list.  To unsubscribe
from this mailing list send a blank message to
BLDG-SIM-UNSUBSCRIBE@xxxxxxxx