[BLDG-SIM] Static pressure reset control

["Mike Tillou" <miket@xxxxxxxxxx>]

Gary,
The VAV Design Guide that Graham mentioned discusses how to model duct
static reset control strategies using eQuest/DOE2.2.  The work includes
performance curves you can utilize to try and model a wide range of
operating conditions.  This is a great resource.  You can download it at
directly at.
http://www.energy.ca.gov/reports/2003-11-17_500-03-082_A-11.PDF  

Good luck,

Mike


Michael Tillou, PE
etc Group, Inc.
PO Box 7, Williamstown, MA 01267
ph. (413) 458-9870  fx. (413) 458-9875

  


-----Original Message-----
From: postman@xxxxxxxx [mailto:postman@xxxxxxxx] On Behalf Of Graham &
Megan
Sent: Sunday, October 17, 2004 5:06 PM
To: BLDG-SIM@xxxxxxxx
Subject: [BLDG-SIM] Static pressure reset control


Gary,
The only mechanism you have in EQuest/DOE-2.2 is to change the
FAN-EIR-FPLR, the way power input varies with flow output.  The most
appropriate curve for you application will depend on the distribution
network, location of duct static pressure sensors, pressure setpoint and
fan selection.  In simple terms constant duct static pressure will vary
flow approximately to the 1.8 to 2.2 power of flow while pressure reset
will approach a cube law as throttling losses are minimised.  The guys
at Taylor Engineering put together quite a good report on VAV systems
earlier this year which is available off the California Energy
Commission's website. Regards, Graham

----- Original Message ----- 
From: "Gary Zeng " <gzeng@xxxxxxxxxxxxxxxx>
To: <BLDG-SIM@xxxxxxxx>
Sent: Wednesday, October 13, 2004 10:58 AM
Subject: [BLDG-SIM] Static pressure reset control


> I am now working on simulation of a 20 floors VAV system,in which the
owner required that the comparation of two kinds of fan control method
should be provided. Can equest run simulation about VAV with fan static
pressure reset control?
>
> Best Regards
>
> Gary Zeng
> Application Engineer
> Royal Service Air-Conditioning Corp. (U.S.A/CHINA) 
> Tel:+86-21-62367175-16 Fax:+86-21-62366379
> E-mail: Gzeng@xxxxxxxxxxxxxxxx
>

=====================================================You received this e-mail because you are subscribed
to the BLDG-SIM@xxxxxxxx mailing list.  To unsubscribe
from this mailing list send a blank message to
BLDG-SIM-UNSUBSCRIBE@xxxxxxxx