Dear bldg-sim users,
I'm trying to size the HVAC equipment in a office in different situations, bu t I get contradictorial results. Which is the best procedure in such calculations in equest? Is it enough just selecting "auto-size" in package HVAC equipment? Where can we find the load calculation results sheet in D2SimViewer?
When adding a layer of insulation to an old non-insulated dwelling (with high inertial mass), I get that the savings in heating are not enough to compensate the rise in cooling demand (and electricity bill). I'm a bit confused there because in my understanding adding insulation would cut down heating deamand, and shoul had little or no effect on cooling season. Had anyone crossed over with the same problem? If anyone had a paper on the subject, I'll appreciate any information.
Regards,
Samuel Casado González
Aspica Constructora
47001 VALLADOLID
España
=====================================================You received this e-mail because you are subscribed to the BLDG-SIM@xxxxxxxx mailing list. To unsubscribe from this mailing list send a blank message to BLDG-SIM-UNSUBSCRIBE@xxxxxxxx