[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[BLDG-SIM] Humidity Control in eQUEST

Title: Humidity Control in eQUEST

2 part question - both regarding Humidity Control in eQUEST (v3.6):

1.

I'm trying to model dehumidification in a VAV system, and I keep getting this error message:


 **WARNING**********************************************************************
             ZONE East Perim Zn (T.E37)          
             might have insufficient heating capability.
             Check that the SYSTEM or ZONE HEATING-CAPACITY plus this
             ZONEs BASEBOARD-RATING is adequate to maintain the ZONE
             specified DESIGN-HEAT-T for the calculated peak ZONE load
             (see LS-A or LS-B for the ZONE peak load.)

             SYSTEM Sys1 (VAVS) (T)                
             which supplies the above listed ZONE, has a design heating
             coil exit temperature, HEAT-SET-T,(plus any zone reheat)
             below its MAX-SUPPLY-T or the ZONE DESIGN-HEAT-T, which
             might account for the insufficient heating capability.

 **WARNING**********************************************************************


I tried doubling the heating capacity, but it sends out the same message. I have experimented with various systems, and it seems like the only system I came across that does seem to be able to model this (or at least shows a rise in energy usage) is the packaged single zone. (I am thinking of using this instead since there is a VAV option with this). Has anyone else run across this? The documentation says that the program should do humidity control with the VAV system.


2.

When I model the building with the packaged single zone system and dehumidification, if I use the add on desiccant option (either liquid or solid), I get a huge increase in heating energy. This seems counterintuitive - I would assume there would be a reduction in heating energy from the lack of reheat (there is some penalty associated with recharging the desiccant, but that shouldn't outweigh the benefits of reheat reduction).


Any guidance on this would be greatly appreciated.

Thanks

Vikram Sami, LEED AP
Direct Phone 404-253-1466 | Direct Fax 404-253-1366

LORD, AECK & SARGENT ARCHITECTURE
Responsive Design · Technological Expertise · Exceptional Service
www.lordaecksargent.com 



=====================================================You received this e-mail because you are subscribed
to the BLDG-SIM@xxxxxxxx mailing list.  To unsubscribe
from this mailing list send a blank message to
BLDG-SIM-UNSUBSCRIBE@xxxxxxxx