[bldg-sim] eQUEST - Parametric Runs

["micha radi" <micharadi@xxxxxxxxxxx>]

Hello there,

I have a problem with creating Parametric Runs Reports, (in eQUEST); I used 
Schematic Wizard first and then went to do the Parametric Runs. I did that 
successfully, or supposedly successful. And when I check the summary 
results, I only got 1 type of summary report! No Parametric Reports!

Is there anything wrong I did?

Is it also possible to change the wall construction materials completely? By 
only adding the resistance value, after creating a material from scratch. I 
tried to change the whole wall materials that were already set via the 
Wizard, and then I got errors and the simulation could not carry on 
performing. Is there any way to include new materials within the Wizard?

Finally, I just want to make sure about something; The thermal conductivity 
has a unit of [Btu in/h-ft^2-F], but in the eQUEST, its as [Btu/h-ft-F]

Your help and advice will be much appreciated!

Thank you..

Micha radi

_________________________________________________________________
Visit MSN Holiday Challenge for your chance to win up to $50,000 in Holiday 
cash from MSN today!  
http://www.msnholidaychallenge.com/index.aspx?ocid=tagline&locale=en-us


======================================================
You received this e-mail because you are subscribed 
to the BLDG-SIM@xxxxxxxx mailing list.  To unsubscribe 
from this mailing list send a blank message to 
BLDG-SIM-UNSUBSCRIBE@xxxxxxxx